| |
 More About Christy's™ Slickwrap |
 |
SLICK-WRAP is a strong, permanent and economical repair system. Works on virtually every kind of pipe. An easy alternative to traditional methods such as cementing, soldering, welding, sleeving and replacement. Works on wet, dry, clean, dirty or corroded pipes. EVEN UNDER WATER!! SLICK-WRAP is ideal for all fluid bearing pipes and hoses:
Water • Steam • Air • Gas • Sewage • Fuel • Hydraulics
and is recommended for structural repairs to:
Brackets • Fencing • Supports • Exhausts & Mufflers • Tools |
|
 |
|
 |
|
 |
| Put on enclosed gloves and clean repair area. Place rolled tape in water (Fresh or Salt) for 20-30 seconds. |
|
Place Slick-Wrap Plug over break.Wrap tape tightly over repair and extend 2”/50mm either side of break. Complete a minimum of 8 complete wraps for high pressure applications. |
|
Continue to squeeze and
tighten on direction of wrap until very tacky. Slick-Wrap will cure to full strength in 30 minutes at 70°F/21°C. |
|
What is Slick-Wrap© ?
Slick-Wrap© is a specially formulated fiberglass tape designed to repair water lines, sewer lines, fluid lines, and virtually anything that transports fluids.
What Pressures will Slick-Wrap© support?
Slick-Wrap© has been tested to support up to 300 PSI in pressurized lines and was able to prevent infiltration by maintaining a pure vacuum.
What types of tools are needed in applying Slick-Wrap©?
No tools are required when applying Slick-Wrap© to pipes as long as there is no corrosion, or coatings of any kind on the pipes when applied.
At what temperature will Slick-Wrap© work?
Slick-Wrap© has been tested in many temperatures ranging from 100 degrees F. to -60 degrees F. Because of
the need for moisture (water) to start the chemical reaction, the temperature variations only have a bearing on the
time frame for the complete curing process to occur. Complete cure in 30-40 minutes.
Can Slick-Wrap© be used on gas pipes?
Slick-Wrap© can be used to prevent gas leaks from corrosion of pipes caused by the elements. Anyone working
with gas pipes should be certified in that area before attempting any repairs.
On what types of pipes can Slick-Wrap© be used?
Slick-Wrap© can be applied to all types of pipes including PVC, Cast Iron, Galvanized, and Clay to name a few.
The uniqueness of Slick-Wrap© lies in its EPA approval for use on drinking water lines, as well as being suitable
for sewer, irrigation, and chemical lines.
What are the chances of the section of pipe breaking again after applying Slick-Wrap© ?
Not only does Slick-Wrap© seal leaks in pipes, it also strengthens the vulnerable area of the damaged pipe
causing it to be even stronger in most instances than it was before.
Is Slick-Wrap© a permanent repair?
Slick-Wrap© can be considered a permanent repair in most industry and home uses. It can also be used as an
emergency fix until a maintenance crew has the time to fit the damaged area into their maintenance schedule. Either way, Slick-Wrap© enables the home owner or maintenance supervisor to make that decision. |
|
|
